Table of Contents
Advertisement
SPECIFYING DYNAMIC JOB DESCRIPTOR ENTRIES (DJDES)
RTEXT
8-56
This parameter specifies text to be printed on a separate page
preceding a report. It takes effect on the next page boundary. The
parameters are the same as for the ROUTE command defined in the
chapter "Print format commands." RTEXT parameters must be in
ascending passnum sequence.
RTEXT = option(s)
Syntax
Options
Table 8-44 lists the parameter option(s) and definition(s).
Table 8-48. RTEXT parameter option(s) and definition(s)
Option(s)
Definition(s)
( sc ,[ passnum
This option has the following components:
|ALL],[ line ,[ col [,
•
fontindex ]]])
•
•
•
•
•
rtext-id
This option is used to reference a cataloged file of RTEXT
parameters previously compiled by PDL.
NONE
Specifies that no text is to be printed on a separate page.
The default is NONE.
Example
RTEXT=('TEST',ALL,15,5,2);
END;
sc
Specifies the message to be printed (1 to 132
characters). It is printed with the first font specified in
the FONTS parameter of the PDE command (refer to
fontindex).
passnum
May be either an integer number or the keyword ALL.
An integer number specifies the pass (copy ply) to
which the text applies.
ALL
Specifies that the text applies to all copies. If there is
more than one RTEXT parameter in a DJDE packet,
passnum must be in increasing numeric order.
The default is passnum = 1.
line
Specifies the line number on which the first line of a
block of RTEXT message is printed. The default is line
1 for the first text string of the pass. Otherwise, the
default is the next line of the page. Only one RTEXT
parameter may be specified per line for a passnum.
col
Specifies the column number at which the first
character of a block of RTEXT messages is to be
printed.
The default is column 1.
fontindex
Identifies the index (starting with 1) of the PDE font with
which the text is printed.
XEROX DOCUPRINT 180 LPS PDL REFERENCE
Advertisement
Table of Contents
