SMITH SYSTEM DESK FENCE Instruction Sheet

DESK FENCE INSTRUCTION SHEET

If you have damaged or missing components please contact customer service.

PARTS LIST

PART NUMBER: 001700

DESK FENCE SCREEN SUB-ASSEMBLY

QTY PER UNIT: 1

PART NUMBER: 001725

DESK FENCE POLE KIT WITH HARDWARE

QTY PER UNIT: 1

Contents of Desk Fence Pole Kit

with Hardware:

800-328-1061

www.smithsystem.com

2 Pole Weldments

2 Clamps w/ Weldnuts

2 Binding Posts

2 Binding Post Screws

4 Long Set Screws

4 Short Set Screws

2 Hex Keys (Allen Keys)

2 Spanner Plates

8 Screws

AUG 2011

Table of Contents

Need help?

Do you have a question about the DESK FENCE and is the answer not in the manual?

Page 1 PARTS LIST PART NUMBER: 001700 DESK FENCE SCREEN SUB-ASSEMBLY QTY PER UNIT: 1 PART NUMBER: 001725 DESK FENCE POLE KIT WITH HARDWARE QTY PER UNIT: 1 Contents of Desk Fence Pole Kit with Hardware: 2 Pole Weldments 2 Clamps w/ Weldnuts...
Page 2 CONFIGURATIONS EDGE-MOUNTED Creates a barrier along the back edge or side edge of the desk *use inner mounting holes of pole tabs* Clamps are optional HALF-MOUNTED Creates a barrier along the center of the desk, creating two separate workspaces. *use center mounting holes of pole tabs* Clamps are optional L-MOUNTED (qty 2 units req'd) Creates a barrier along the rear edge and...
Page 3 1. BUILD YOUR DESK FENCE PROJECTED BOSS Step 1: Fit the projected boss of the desk fence screen between the two welded tabs of each pole. Align the hole of the projected boss with one of the tab holes. Step 2: Insert the Binding Post into one of the holes of the top tab and also pass the binding post through the projected boss of the desk fence screen.
Page 4 2. SECURE THE DESK FENCE TO THE WORK SURFACE OPTION A: PERMANENT FASTENING - FASTEN THE DESK FENCE TO THE WORK SURFACE USING SCREWS Using the 8 screws included in the hardware pack of the pole kit, you can fasten the desk fence to your work surface.
Page 5 SPANNER PLATE If you would like to use the desk fence to span two desks, (2 desks, sharing 1 fence) use the two spanner plates included in the hardware pack. Isometric View desk 1 desk 2 clamp set screws spanner plate...