Indicating The Input Resolution - Xerox DocuPrint 4850 Configuring

SETTING THE SYSTEM CONFIGURATION

Indicating the input resolution

4-6
This section describes the procedure for communicating the
resolution of the fonts used in the incoming job to the IPS. The IPS
then reports this information to PSF.
Caution: The resolution you indicate on this window must match
the font resolution in your host input data stream. Conflicts between
the input font resolution and the IPS configuration may result in
inability to print the job, or in blank output pages.
To indicate the resolution of fonts and other input resources:
1. From the Configuration menu, select Resolution. The
Resolution window displays.
Figure 4-2.
2. Click the resolution of the input resources.
3. Click Apply.
4. Drain the printer at the host. (Follow procedures for your host
system.)
5. Reboot the Printer Controller.
6. Restart the PSF printer session, or the Functional Sub System.
XEROX DOCUPRINT 4850/4890 IPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM
Resolution window