Xerox DocuPrint 4850 Configuring page 116

SETTING THE SYSTEM CONFIGURATION
Specifying stitching attributes
(for systems with a stitcher)
4-60
To specify stitching attributes, follow these steps:
1. On the Output Configuration window, check the "Stitching" box,
then click the Stitching Attributes button. The Stitching
Attributes window displays.
Figure 4-46. Stitching Attributes window
2. On the Stitching Attributes window, make selections or enter
values in the fields described below.
•
Set Sheet Delivery — Specifies whether sheets will be
delivered Face Up or Face Down.
•
Page Order within Set — Specifies the order in which
pages in a set will be delivered to the output bin: first-to-last
or last-to-first.
— 1 to N — Output sheets are delivered to the output bin
— N to 1 — Output sheets are delivered to the output bin
Note: The size of the ordered set must fall within the
specified maximum set size.
•
End of Set Criteria — Specifies the criterion that marks the
end of a set for your system.
— Offset Stacker — A JOG (offset) command in the job
— MarkForm — A MARKFORM command in the job
•
Maximum Set Size — Specifies the maximum number of
sheets that can be in a set. The range for DFA sets is 10 to
50.
XEROX DOCUPRINT 4850/4890 IPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM
in ascending order (the first page is delivered first).
in descending order (the last page is delivered first).
indicates the end of a set.
indicates the end of a set.