Table of Contents
Advertisement
4-41 PAUSING AND RESTARTING SCANS:
In Programmed or Memory/Scan mode, push the unlit Pause button to enter Pause mode,
temporarily stopping the scanning at the current frequency or channel. The Pause LED
lights, and the Memory/Scan display reads:
where XX.... or YY is the current frequency or channel in the scan sequence.
When a scan is Paused, the displays reflect the presently active Receive Frequency and
Auxiliary Parameters. The scan can be restarted at the next Channel or Frequency in the
scan sequence by pushing the Pause button again, extinguishing the Pause LED. The
next Channel or Frequency is held for a minimum of one second to allow double pushes
of the Pause button to single step through the scan sequence.
Pause mode may also be exited by pushing the lit PScan or MScan button. This will exit
both Pause and Scan modes, extinguishing the Pause and MScan or PScan LEDs. This
will not return the Memory/ Scan, Auxiliary Parameter, Main Display and Receive
Frequency to the settings that existed before the scan was started.
In Pause mode, the receiver can be tuned and Auxiliary Parameters can be changed to
look more closely at the received signal. In Paused PScan mode, the XX...frequency
displayed in the Memory/Scan Display remains fixed regardless of any receiver tuning
adjustments. Any changes to the Auxiliary Parameters are ignored when the scan is
restarted.
Scan Setup Parameters can be changed while a scan is paused. The Scan Setup
procedures are the same as before except the Select Scan Type prompt never appears, and
the Pause LED is lit. When Pause and Scan Setup modes are enabled concurrently,
pushing the lit Pause button will exit both modes and restart the scan.
In PScan Pause mode, frequency lockouts may be added to the lockout list. Push the
Lockout button to store the current receiver tuned frequency and IF Bandwidth in one of
the Lockout memory locations. The Memory/Scan Display reads:
4-30
Advertisement
Table of Contents
