Table of Contents
Advertisement
2. Adding Frequency Lockouts: Frequency Lockouts are normally added when the
PScan is in progress becomes halted by an unwanted station. To add a lockout, first press
Pause to suspend the scan, then press Lockout. The Pause button will illuminate and a
prompt will appear in the display to confirm the frequency (example, 12.1 MHz center
with 5 kHz BW):
To add the indicated lockout, press Lockout a second time. The display will change to
show the entry has been recorded:
After your entry is complete, press Pause off to resume scanning. The LED will go out
and the display will revert to the normal PSCAN running message:
If you decide to not enter a lockout after setting it up, first press 'C' (clear) on the main
keyboard, then press Pause to escape. Note that Pause will not disengage unless the
Lockout command is either completed (with a second press) or canceled via the keypad,
by pressing 'C'.
3. Channel Lockouts from Main Tuning: Finally, it is possible to toggle frequency
Lockouts in or out of the channel list while remaining in receive mode. Simply press the
Lockout button while the desired frequency is displayed during normal receiver
operation, and a confirmation message will appear in the Memory/Scan window. By
pressing the Lockout button a second time, the Memory/Scan window will confirm
Lockout deletion.
Important Note: You must press Pause to suspend the PScan before attempting to enter
the Lockout command. If you press Lockout without first pausing the scan, the display
will prompt you to use the Pause button:
4-25
Advertisement
Table of Contents
