Clearing Occupied Channels To Create Empty - Ten-Tec RX-340 Technical Manual

2. To Store a channel while in Tune mode: To overwrite a stored channel with the
frequency incur- rent use, press the Store button. The display will present a confirmation
request:
If you wish to complete the overwrite, press Store one more time. The old information
will be overwritten and the current operating frequency will replace it. Also, the display
will revert to channel-menu format:
If you do not wish to complete the overwrite when the confirmation message appears,
press 'C' on the main keypad to escape.
4-33 Clearing Occupied. Channels to Create Empty Channels: This function is used
to clear un-needed frequencies from the program menu, emptying slots for future use.
Channel clearing is done via the Tune mode.
Begin by pressing the Tune button. It will illuminate and the Edit Knob will be assigned
to the tune function. Rotate the Edit Knob to the channel you wish to clear, as shown
below:
1. Clear a Single Channel: When the desired channel-menu entry appears in the
Memory/Scan display, press 'C' (Clear) on the main keypad. A confirmation request will
appear in the Memory/Scan window:
The confirmation message remains on-screen for approximately two seconds. During
that interval press 'C' again to clear the channel. The display will change to:
This message will remain on screen for about two seconds. At the end of that interval,
the menu will advance to the next-higher menu entry.
4-18