To Set Up A Memory/Scan Frequency Sweep - Ten-Tec RX-340 Technical Manual

4-38 TO SET UP A MEMORY /SCAN FREQUENCY SWEEP: The MScan mode is
used to search frequencies stored in the receiver's channel memory for activity. To enter
the scan setup mode, press the Setup button. It will illuminate and a 'Select Scan Type'
message will appear in the display:
Now, press the MScan button. It will illuminate, the Edit Knob will be assigned to the
MScan menu, and the display will present the 'Start Channel' menu prompt which
includes the previous start point:
1. Start Channel: To enter a new Start Channel, use the main keypad to keystroke in
the desired channel as a three-digit number (001, 050, 100, etc). Your entry will appear
in the Memory/Scan display window, and will overwrite into memory automatically when
the third digit is entered: (example, enter 050 for channel 50):
Important Note: For this and other scan parameters, terminate entries with MScan button
or turn on the Memory/Scan edit knob.
If you make a mistake while entering, press 'C' to clear the entry. If you wish to change
the start point after entry is complete, simply start over.
2. Stop Channel: Rotate the Edit Knob clockwise to the next menu prompt; 'Stop
Channel' with the last-entered selection:
To enter a new Stop Channel, use the main keypad (as in step-1) to keystroke in the
desired three-digit channel number (example, 080 for channel 80):
If you make a mistake while entering the channel, press 'C' to clear the entry. If you
wish to change the start point after entry is complete, simply start over.
4-26