schmersal PSC1 Installation Manual page 90

Installation manual
The Scan Network button runs the search. All devices with activated DHCP, but without
assigned IP address, are then listed in the DHCP Requests list. The desired IP address can
now be entered in the IP-Address text field and is transferred via DHCP to the connected
PSC1 via the Set IP Address via DHCP button. This process may take a moment.
PSC1 without assigned IP-Address and
DHCP activated
The device now appears automatically in the Device List. All PSC1 devices already having
an IP address assigned are listed here.
If the IP address is to be permanently assigned, the DHCP service must be deactivated via
Disable DHCP on selected device. Message about the successful deactivation is displayed in
the Notifications area.
Changing an IP address
To assign a new IP address to a PSC1 device, the device first must be selected in the
Device List and then via Enable DHCP on selected device DHCP must be activated for this
device. After the message about successful execution a power-on reset is recommended.
Afterwards the device is accessible via DHCP and can be found in the DHCP Requests list.
Please then follow the procedure described above.
Installation manual PSC1-Field buses V2.2.docx
PSC1 with assigned IP-Address
Page 90 of 166