Post Installation Tasks For Windows Server; Supplemental Software Component Options - Oracle Server X5-2 Installation Manual

Post Installation Tasks for Windows Server

Note -
Server operating system using the manual procedure, that is, you did not use Oracle System
Assistant. If you used Oracle System Assistant to install your operating system, you can skip
this section because Oracle System Assistant performed these post installation tasks for you.
After completing a manual installation of the Windows Server 2012 or 2012 R2 and rebooting
the server, you should review the following post installation tasks and, if necessary, perform the
tasks that are applicable to your server.
Description
About Supplemental Software.
Install device drivers and supplemental software.
Configure NIC teaming.

Supplemental Software Component Options

Oracle System Assistant makes several Supplemental Software components available for the
server. You have two options for installation:
Typical – Installs all Supplemental Software applicable for your server.
■
Custom – Installs only the Supplement Software selected for installation.
■
The following table identifies the optional Supplemental Software components that Oracle
System Assistant makes available for your server.
TABLE 2 Optional Supplemental Software
Available Supplemental Software Components
Emulex OneInstall for Windows Servers
The procedures in this section assume that you have installed the Microsoft Windows
Link
"Supplemental Software Component
Options" on page 65
"Installing Device Drivers and Supplemental
Software" on page 66
"Configuring Intel NIC Teaming" on page 68
Post Installation Tasks for Windows Server
Integrated
RAID
Controller
Typical
65