Acorn 80 Installation Manual page 51

11 Release the Swivel paddle and check to see that the motor gear teeth are in mesh with the motor quadrant
on the base of the seat.
ENSURE MOTOR GEAR
IS IN MESH WITH
MOTOR QUADRANT
12 Check the positioning of the quadrant by checking the alignment of the seat spacer when the swivel is
moved to its fully closed position. Adjust the quadrant (118CSBM29 or 118CSBM28) slightly until level
with seat base.
13 Spray Gear quadrant with Fin grease (902231)
SHOULD BE LEVEL
WITH THE SEAT BASE
OR SLIGHTLY ABOVE
14 Connect the options and seat harnesses from the seat to the harnesses from the carriage.
ACORN 80 Installation Manual
Rationalisation Procedures
CHECK MESHING IN
3 POSITIONS
MUST NOT BE BELOW
EDGE OF SEAT BASE
WHEN FULLY CLOSED
OPTIONS HARNESS
ARM HARNESS
APPENDIX 10
51