Acorn 80 Installation Manual page 23

The carriage can be stopped at any time during programming, and if a mistake is made the program can be
over written.
IF ANY REPROGRAMMING IS REQUIRED WITHIN 150MM OF EITHER THE TOP OR BOTTOM
DO
1 Set the final limit striker in the correct position
2 Only program to the measurements stated in the manual
3 Only program in the down direction
4 Always program creep speed at both terminal stops
5 Ensure confirmation of reset indication on display
6 Do reprogram the final limit if you have reprogrammed within 150mm of the terminal limit
DO NOT
1 Do not move the top charge point after datum has been set
2 Do not alter the level calibration potentiometer before or after programming
ACORN 80 Installation Manual
LIMITS, THE FINAL LIMIT MUST BE REPROGRAMMED AS WELL.
SECTION 8
8.1.10 Amending The Program
8.1.11 Programming Do's & Don'ts
Programming
23