Acorn 80 Installation Manual page 16

SECTION 6
Fitting Seat to Carriage
FITTING SEAT TO CARRIAGE
1 Apply the recommended grease to the swivel pin – see Appendix 3.
Ensure grub screw (G) is tight and the seat pin is secure.
2 Place the thrust washer (T) over the swivel pin.
(Only applies to power swivel).
3 Position the seat square with the main frame and locate
the swivel pin into its bearing bush, ensuring the thrust
washer is located, where applicable.
4 Hold paddle arms down and push the seat fully down into the frame (F).
5 Check the seat swivel locking mechanism operates correctly,
using the swivel paddles (SP).
6 Connect the seat wiring (W) to the PCB connector.
16
ACORN 80 Installation Manual