Cleaning The Water Intake Filter - Miele WTR 860 WPM Operating Instructions Manual

Cleaning and care

Cleaning the water intake filter

The washer-dryer has a filter to protect
the water intake valve. The filter at the
open end of the water inlet hose should
be checked approximately every
6 months. Perform this check more of-
ten if there are frequent interruptions to
the external water supply.
 First turn off the stopcock.
 Unscrew the water inlet hose from the
stopcock.
 Remove the rubber seal 1 from the
recess.
 Hold the free end of the water inlet
hose upside down. The plastic filter 2
will fall out.
 Clean the plastic filter.
 Reassemble in reverse order.
 Turn on the stopcock and check that
the connection is watertight. If water
drips out, tighten the connection.
Never forget to put the filter back in
place after cleaning.
82