Miele WTR 860 WPM Operating Instructions Manual page 43

Final spin speed in wash programme
When a programme is selected, the op-
timum spin speed for this wash pro-
gramme is shown in the display.
A faster spin speed can be selected for
certain wash programmes.
The highest selectable spin speed is in-
dicated in the table.
Omitting the final spin (Rinse hold)
 Select the
Rinse hold
The laundry is not spun after the final
rinse cycle and remains in the rinse wa-
ter. This helps prevent creasing if the
laundry is not going to be removed from
the drum immediately after the end of
the programme.
To start the final spin:
The wash programme is set to the op-
timum spin speed. You can change the
spin speed.
 Touch the
Change spin speed
control.
 Select the desired spin speed.
 Start the final spin with the Start/Stop
control.
Ending the programme:
 Touch the
Change spin speed
control.
 Select the spin speed
spin).
 Touch the Start/Stop sensor control.
The water will be pumped away.
Extra.
sensor
sensor
0 rpm (no
Rinse-spin
There is a spin cycle after the main
wash and between the rinse cycles. A
reduction in the final spin speed will
also reduce the rinse-spin speed as ap-
propriate.
Omitting the rinse-spin and the final
spin
 Touch the
Spin speed
 Select the spin speed
spin).
After the last rinse, the water will be
pumped away and the anti-crease
phase will switch on.
In some programmes an extra rinse is
introduced with this setting.
WASHING
sensor control.
(no
0 rpm
43