Mitsubishi Electric M Series Manual page 566

MULTI SYSTEM Inverter Heat Pump
3. Installation location
Fig. 3-5
Fig. 3-9
Fig. 3-12
i F . g 3 1 - 5
3.4.2. When installing a single outdoor unit
Minimum dimensions are as follows, except for Max., meaning Maximum dimensions,
indicated.
Refer to the figures for each case.
Obstacles at rear only (Fig. 3-5)
Obstacles at rear and above only (Fig. 3-6)
Obstacles at rear and sides only (Fig. 3-7)
Obstacles at front only (Fig. 3-8)
When using an optional air outlet guide, the clearance is 500 mm or more.
Obstacles at front and rear only (Fig. 3-9)
When using an optional air outlet guide, the clearance is 500 mm or more.
Obstacles at rear, sides, and above only (Fig. 3-10)
• Do not install the optional air outlet guides for upward airflow.
C-564
Fig. 3-6
Fig. 3-10
i F . g 3 1 - 3
i F . g 3 1 - 6
3.4.3. When installing multiple outdoor units
Leave 10 mm space or more between the units.
Obstacles at rear only (Fig. 3-11)
Obstacles at rear and above only (Fig. 3-12)
• No more than 3 units must be installed side by side. In addition, leave space as shown.
• Do not install the optional air outlet guides for upward airflow.
Obstacles at front only (Fig. 3-13)
When using an optional air outlet guide, the clearance is 1000 mm or more.
Obstacles at front and rear only (Fig. 3-14)
When using an optional air outlet guide, the clearance is 1000 mm or more.
Single parallel unit arrangement (Fig. 3-15)
When using an optional air outlet guide installed for upward airflow, the clearance is
1000 mm or more.
Multiple parallel unit arrangement (Fig. 3-16)
When using an optional air outlet guide installed for upward airflow, the clearance is
1500 mm or more.
Stacked unit arrangement (Fig. 3-17)
• The units can be stacked up to 2 units high.
• No more than 2 stacked units must be installed side by side. In addition, leave space as shown.
Fig. 3-7
1500
500
i F
i F
M series
Fig. 3-8
Fig. 3-11
. g 3 1 - 4
. g 3 1 - 7