Electro-Voice X‑LINE ADVANCE X1i Rigging Manual page 8

8 en | Installation
Notice!
A mirror image array may be assembled by inverting all the elements in that array.
All elements in a single array must be oriented in the same direction.
Rigging installation is the same in either orientation.
2020-06 | V03 | F01U361023
4.
BIAMP OPERATION ONLY PARALLEL BIAMP OPERATION ONLY
CONNECTORS
THRU 1+ 1+ THRU
1- 1-
2+ 2+
THRU THRU
2- 2-
3+ 3+
LF 8 OHMS LF 8 OHMS
500 WATTS 3- 3- 500 WATTS
4+ 4+
8 OHMS HF HF 8 OHMS
150 WATTS 4- 4- 150 WATTS
PARALLEL
CONNECTORS
5.
6.
7.
8.
M10
6mm
Rigging manual
X-LINE ADVANCE install system rigging
Orient the first enclosure as determined in
PREVIEW. The element is right side up when the
input cup is towards the top of the element. The
element is upside down when the input cup is
towards the bottom of the element.
Add a flat washer onto each M10 bolt.
Add the nylon sleeve until the end of the sleeve is
flush with the end of the M10 bolt.
Remove the top M10 flat head screw on each side of
the element.
Set screws aside to be properly recycled later.
Bosch Security Systems B.V.