10
en | Installation
X2i
X1i
A
B
2020-06 | V03 | F01U361023
18. Repeat steps 9 through 17 on the opposite side of
the element.
Note the orientation of the spreader bar if using a single
suspension point. The spreader bar needs to be oriented
differently for X1i and X2i elements to ensure that the
array suspends properly. The spreader bar must be
oriented as shown while looking at the front of the array.
19. Option A: Align the grid spreader bar with the holes
on the grid side arms as indicated in PREVIEW.
20. Option B: If a second spreader bar is required, place
the front spreader bar in the "1" hole, and the rear
spreader bar in the "20" hole. (The second spreader
bar is sold separately.)
Rigging manual
X-LINE ADVANCE install system rigging
Bosch Security Systems B.V.