Electro-Voice X‑LINE ADVANCE X1i Rigging Manual page 18

18 en | Installation
2020-06 | V03 | F01U361023
5. Align the bottom element in the array with the
previous element. The front link bars should be
aligned with the top front holes in the bottom
element.
6. Apply threadlocker and insert the M10 bolt through
the top hole of the front plate, through the link bar
of the previous element, and into the top front
suspension point of the bottom element.
7. Tighten by finger for now.
8. Apply threadlocker and insert the M10 bolt through
the bottom hole of the front plate, through the top
hole of the large round spacer, and into the bottom
suspension point of the bottom element.
9. Tighten by finger for now.
10. Repeat steps 6 through 9 on the opposite side of the
array.
11. Align the rear link bar on the bottom element so that
the bottom of the rear plate aligns with the desired
splay angle.
Note: 0° splay angle shown.
12. Apply threadlocker and insert the M10 bolt through
the bottom hole of the rear plate, through the
correct hole on the rear link bar, and into the bottom
rear suspension point on the previous element.
13. Tighten by finger for now.
Rigging manual
X-LINE ADVANCE install system rigging
Bosch Security Systems B.V.