20
en | Installation
Notice!
Note the orientation of the spreader bar. The spreader bar needs to be oriented differently
for X1i and X2i elements to ensure that the array suspends properly.
The spreader bar must be oriented as shown, while looking at the front of the array.
X2i
X1i
2020-06 | V03 | F01U361023
2.
Apply threadlocker and insert the M10 bolt through
the bottom holes in the plate, through the grid side
arm, and into the bottom suspension points of the
bottom element.
3.
Torque to 13.5 N*m (120 in*lbs.)
4.
Repeat on the opposite side of the array.
5.
Apply threadlocker and insert the shoulder bolts
through hole 20 of the side arms, into the ends of the
spreader bar.
6.
Torque to 13.5 N*m (120 in*lbs.)
6 mm
2x
Rigging manual
X-LINE ADVANCE install system rigging
Bosch Security Systems B.V.