Electro-Voice X‑LINE ADVANCE X1i Rigging Manual page 16

16 en | Installation
2020-06 | V03 | F01U361023
12. Repeat steps 9 through 11 on opposite side of
element.
13. Align the rear link bar on the next element so that
the bottom of the rear plate aligns with the desired
splay angle.
Note: 0° splay angle shown.
14. Apply threadlocker and insert the M10 bolt through
the bottom hole of the rear plate, through the
correct hole on the rear link bar, and into the bottom
rear suspension point on the previous element.
15. Tighten by finger for now.
16. Torque all M10 bolts on the previous element to 13.5
N*m (120 in*lbs).
17. Repeat steps 1 through 16 for each element in the
array except the last element.
Rigging manual
X-LINE ADVANCE install system rigging
Bosch Security Systems B.V.