Table of Contents
Advertisement
X-LINE ADVANCE install system rigging
Notice!
The side arms can be installed in the standard orientation (Orientation A) or in reverse
orientation (Orientation B). Use the reverse orientation when the array needs to be
suspended with the top element at an upward angle. Consult PREVIEW to determine whether
the side arms need to be reversed to achieve the desired coverage. Always attach both side
arms in the same orientation.
Bosch Security Systems B.V.
9.
Orientation A (standard): Align the front plate of the
rigging kit with the front mounting hole of the grid
side arm. The front mounting hole is located below
the hole marked with a "1".
Orientation B (reverse): Align the front plate of the
rigging kit with the rear mounting hole of the grid
side arm. The rear mounting hole is located below
the holes marked with a "15" and "20".
10. Apply threadlocker to the M10 bolt and insert
1
through the top hole of the front plate, the front
mounting hole of the grid sidearm, and into the top
front suspension point in the element.
11. Tighten by finger for now.
12. Apply threadlocker and insert the M10 bolt through
the lower front plate hole, the link bar, and the into
the front bottom suspension point in the element.
13. Tighten by finger for now.
20
14. Apply threadlocker and insert the M10 bolt through
the top hole of the rear plate, through the rear-
mounting hole of the grid sidearm, and into the top
rear suspension point of the element.
15. Tighten by finger for now.
16. Apply threadlocker and insert the M10 bolt through
the middle hole of the rear plate, through the small
round spacer, and into the suspension point from
step 7.
17. Tighten by finger for now.
Rigging manual
Installation | en
9
2020-06 | V03 | F01U361023
Advertisement
Table of Contents
