Notes About The License - Peak PCAN-PC/104-Plus User Manual

PCAN-PC/104-Plus – User Manual
Additional settings can be made, e.g. setting up message filters to
confine to specific CAN IDs or setting the CAN controller to listen-
only mode.
When receiving CAN messages, events are used for an automatic
notification of an application (client). This offers the following
advantages:
The application no longer needs to check for received messages
periodically (no polling).
The response time at reception is reduced.
Completion
To end the communication the function
order to release the reserved resources for the CAN channel, among
others. In addition the CAN channel is marked as "Free" and is
available to other applications.
4.2.3

Notes about the License

Device drivers, the interface DLL, and further files needed for linking
are property of the PEAK-System Technik GmbH and may be used
only in connection with a hardware component purchased from
PEAK-System or one of its partners. If a CAN hardware component
of third-party suppliers should be compatible to one of PEAK-
System, then you are not allowed to use or to pass on the driver
software of PEAK-System.
If a third-party supplier develops software based on the PCAN-Basic
and problems occur during the use of this software, consult the
software provider.
CAN_Uninitialize
29
is called in