Display And Control Elements; Rotary Push Button; Back Button; Initial Start-Up - Truma VarioHeat Operating Instructions Manual

Display and control elements

6
7
9
Figure 2
1 = Display
2 = Status bar
3 = Menu bar (upper)
4 = Menu bar (lower)
5 = 230 V mains supply indicator (power)
6 = Time switch display
7 = Settings / Values

8 = Rotary push button

9 = Back button

The menus can be selected in lines (3 + 4) and settings can be
made using the rotary push button (8). The display (1) has an
illuminated background. The Back button (9) can be used to
return from a menu.
Rotary push button
Setpoints and parameters can be selected and modified using
the rotary push button (8) and saved by tapping on it. Select-
ed menu items flash.
+
1
Rotate clockwise
2
3
Figure 3
5
-
Rotate anticlockwise
4
8 Figure 4
Tapping
Figure 5
Long press
Back button
Pressing the Back button (9) returns you from a menu and
discards settings. This means that the previous values are
retained.

Initial start-up

In order to perform the initial start-up, the following steps are
required:
– Switch on power supply.
12 V direct voltage for the Truma CP plus VarioHeat and
Truma VarioHeat control panel, or the 230 V mains voltage
for the air conditioning systems.
– Start the search of the appliances under the menu item
"Service menu" -> "RESET" -> "PR SET".
After confirmation, the Truma CP plus VarioHeat control panel
initialises itself. "INIT .." appears on the display while this is in
progress. The appliances that have been found are stored in
the control panel.

Start-up

Start / stand-by screen
After connecting the Truma CP plus VarioHeat control panel
to the power supply, a start screen is displayed after a few
seconds.
Figure 6
– The display changes between the time and the set
room temperature.
– Special displays on command via IR remote control
of the air conditioning system or CI-BUS (see "Special
displays" on page 11).
– After a repair / retrofit, the procedure described under
"Initial start-up" must be repeated.
– Menu is run through from left to right.
– Increase values (+).
– Menu is run through from right to left.
– Decrease values (-).
– Accept (save) a selected value.
– Select a menu item, switch to setting
level.
– Main switch function ON / OFF.
7