Converting Between Flash And Ice Mode; Introduction; Converting To Flash Mode From Ice Mode - Atmel AT43DK370 User Manual

6.1

Introduction

6.2 Converting to
Flash Mode from
ICE Mode
AT43DK370 USB Host/Function Dev. Kit User Guide
Converting Between FLASH and ICE
By default the sample template is configured in ICE mode to run with In-Circuit Emula-
tor. It can also be converted to Flash mode to generate the Hex file to be programmed
onto the DK flash set, and the Download mode to generate the Hex file to be down-
loaded onto the DK SRAM using USB Clinic. The steps to convert between ICE mode,
Flash mode and Download mode are as follows.
1. In ADS go to DebugRel > Linker > ARM Linker > Options
2. Under Image entry point specify address 0x0 (see Figure 6-1)
Figure 6-1. DebugRel Settings Window
Section 6
Mode
6-1
3423C–USB–1/04