Mitsubishi Electric MELDAS MDS-R Series Technical Specification And Instruction Manual page 144

No. Abbrev. Parameter name
Deceleration time
SV056 EMGt constant at
emergency stop
SV057 SHGC SHG control gain
SHG control gain in
SV058 SHGCsp spindle synchronous
control
SV059
SV060
D/A output channel 1
SV061 DA1NO
data No.
D/A output channel 2
SV062 DA2NO
data No.
D/A output channel 1
SV063 DA1MPY
output scale
D/A output channel 2
SV064 DA2MPY
output scale
SV065
SV066
System setting
to
parameter
SV080
SV081
to
SV088
TQMAX Torque maximizing
SV089
Kq control Kq gain
TQMAX Torque maximizing
SV090
Kd control Kd gain
SV091
to
SV100
8. Setup
In the vertical axis drop prevention time control, set the time constant used
for the deceleration control at emergency stop. Set a length of time that
takes from rapid traverse rate (rapid) to stopping.
Normally, set the same value as the rapid traverse acceleration/deceleration
time constant.
When performing the SHG control, set this with S003 (PGN1) and SV004
(PGN2).
When not performing the SHG control, set to "0".
Set this with SV049 (PGN1sp) and SV050 (PGN2sp) if you wish to perform
the SHG control in the spindle synchronous control (synchronous tapping,
synchronous control with spindle/C axis).
When not performing the SHG control, set to "0".
Not used. Set to "0".
Not used. Set to "0".
Input the No. of the data to be output to the D/A output channel.
When "0" is set, the data is output with the standard output unit.
Set a value other than 0 to change the output unit.
The scale is set with a 1/256 unit. When 256 is set, the unit is the same as
the standard output unit.
Not used. Set to "0".
These parameters are set automatically by the NC system.
Not used. Set to "0".
Normally set this to "0". (For machine tool builder adjustment)
Normally set this to "0". (For machine tool builder adjustment)
Not used. Set to "0".
8 - 20
Explanation
Setting range
(Unit)
0 to 20000
(ms)
0 to 1200
(rad/s)
0 to 1200
(rad/s)
0
0
0 to 102
-32768 to
32767
(Unit: 1/256)
0
0
0 to 32767
0 to 32767