Omcan MS-IT-0300-IP Instruction Manual page 13

Maintenance
DO NOT PROLONG THIS OPERATION BEYOND THE FEW SECONDS MENTIONED OTHERWISE THE
BLADE EDGE WILL WARP.
6. After completing sharpening, we advise cleaning the wheels using a small brush and alcohol;
7. Now return the sharpener to its original position.
LUBRICATION
Carriage sliding guides product grip (once a week)
Use the Omcan oil #27336, otherwise use white Vaseline oil. DO NOT USE VEGETABLE OILS.
• Spread a small quantity of oil on the bar and move the assembly 3 or 4 times;
Clean as required to remove excess of oil.
ADJUSTING THE MOTOR BELT TENSION
After a given period of service an unusual noise may occur because of the belt bedding. In this case, tighten
the belt-stretcher on the side of the motor under the machine base.
13