Page 1
Clipper Building instructions Clipper Order No. 3002/00 “aero-naut” Modellbau Stuttgarterstr. 18-22 D-72766 Reutlingen Germany http://www.aero-naut.de Clipper building instructions...
Page 2
24) Glue the roof 38 to the superstructure. 25) Glue the superstructure floor 34 to the deck 1, leaving a visible gap about 1 mm wide between the wall 35 and the access opening in the deck 1. Clipper building instructions...
Page 3
40) The boat is intended for light to medium-strength winds only. If the boat heels (leans over) too far, give the sails a little more freedom to swing out. This is accomplished by adjusting the position of the sliding clamp 56. Clipper building instructions...
Page 4
6 Ø x 160 mm Screw Brass M2 x 12 mm Self-locking nut Brass Sliding clamp Plastic Ready made Cord 1000 mm Ring-screw Brass Ready made Servo plate Plywood Die-cut Rudder pushrod Steel Ready made Sanding block Plywood Pre-cut Glasspaper Pre-cut Clipper building instructions...