Adjuster Assembly - PINARELLO DOGMA F12 Series Assembly Manual

10
. INTEGRATED HANDLEBAR (TALON ULTRA) ROUTING (MECHANICAL)
10.5

Adjuster assembly:

- Cut the RD and FD housings in correspondence of the lower short edge of the DT
opening. Make sure the housings are properly positioned in the frame, to prevent
them from being twisted together and/or scratched.
- Install the metal end cap on the FD housing and the plastic one on the RD housing.
- Insert the FD housing (with metal end cap) in the front left hole of the adjuster case
. The lower wedge
1
coming out of the case's left back hole. Pay attention to insert the metal end cap
2
also in the lower wedge
and the Teflon pipe
3
- Insert the RD housing on adjuster using the case
31
28
must be held in place, inside the case
3
seat. In this way the FD housing, the case
3
are a single body. Make sure to properly grease the wedge.
2
CICLI PINARELLO S.R.L. | Viale della Repubblica, 12 - 31020 Villorba (TV) - Italia
C.F. - R.I. - P.IVA IT 05994100963 | tel. +39 0422 42 08 77 | fax +39 0422 42 18 16 | www.pinarello.com
FD
, by the Teflon pipe
1
1
right hole.
1
RD
, the wedge