Integrated Handlebar (Talon Ultra) Routing (Electronic Di2) - PINARELLO DOGMA F12 Series Assembly Manual

9
. INTEGRATED HANDLEBAR
(TALON ULTRA) ROUTING (ELECTRONIC DI2)
ATTENTION! If you do not install the integrated handlebar (Talon ULTRA), but instead
a traditional stem and bar (or the Talon AERO); refer to this chapter in regard to the
electronic cable routing inside the frame. Please refer to chapter "13. STEM AND BAR
INSTALLATION AND ROUTING (FOUR CONFIGURATIONS)" for more details about
traditional stem and bar assembling.
Install the shift levers on the Talon Ultra handlebar following the OEM specs.
9.1
Route the Y junction EW-JC130-SM from the middle of the handlebar to left and right exit
9.2
hole. Connect Y junction connectors to the shift levers.
9.3 Connect the Y junction with the junction port EW-JC200 and with the 1000 mm cable
EW-SD50.
- Route the electronic cable through the stem until the left exit hole
- Pull the electronic cable EW-SD50 out of the stem exit hole. The junction EW-JC200
must be completely hidden in the stem.
25
VIEW FROM BELOW!
CICLI PINARELLO S.R.L. | Viale della Repubblica, 12 - 31020 Villorba (TV) - Italia
C.F. - R.I. - P.IVA IT 05994100963 | tel. +39 0422 42 08 77 | fax +39 0422 42 18 16 | www.pinarello.com