Bosch FPC‑500 Operation Manual page 20

20 en | Operation
2
You can use the arrow keys to switch between the individual
entries. If you press and hold an arrow key, the display moves
10 steps in the corresponding direction. A description of the
displayed events can be found on Test Memory Messages, page
35.
If the test log should be disabled, "No Entry" appears on the
LCD.
Displaying alarm counters
Call up the menu; see Opening the menu, page 18
i
The alarm counter cannot be deleted. It only counts alarms
triggered by zones up to 999. It does not count pre-alarms or
evacuations triggered manually via the panel or the inputs.
Displaying SW Release
Call up the menu; see Opening the menu, page 18.
i
1
Displaying the operation days
Call up the menu; see Opening the menu, page 18
i
2
2019.07 | 5.1 | F.01U.172.982
Press zone key 2.
The messages in the test memory are displayed.
Press the "Menu" key and then zone key 3.
3
The LCD shows the number of alarms since the
initial start-up.
Press the "Menu" key and then zone key 4.
4
This takes you to the System Info submenu.
Press zone key 1.
The software version is displayed.
Press the "Menu" key and then zone key 4.
4
This takes you to the System Info submenu.
Press zone key 2.
The number of operation days is displayed
Conventional fire panel
Bosch Sicherheitssysteme GmbH