Control Terminals - Danfoss VLT Micro Drive FC 51 Operating Manual

VLT® Micro Drive FC 51
Operating Guide
• Use a shielded/armored motor cable to comply with EMC emission specifications, and connect this cable to both the decou-
pling plate and the motor metal.
• Keep motor cable as short as possible to reduce the noise level and leakage currents.
• For further details on mounting of the decoupling plate, see VLT® Micro DriveFC 51 Decoupling Mounting Plate Instructions.
• Also see the chapter EMC-correct Electrical Installation in the VLT® Micro DriveFC 51 Design Guide.
Mounting of Ground Cable, Mains, and Motor Wires
Illustration 2: Mounting of Ground Cable, Mains, and Motor Wires
• Mount the ground wires to PE terminal.
• Connect motor to terminals U, V, and W.
• Mount mains supply to terminals L1/L, L2, and L3/N (3-phase) or L1/L and L3/N (single-phase) and tighten.

3.7 Control Terminals

All control cable terminals are located underneath the terminal cover in front of the drive. Remove the terminal cover using a screw-
driver.
Illustration 3: Removing Terminal Cover
12 | Danfoss A/S © 2020.09
Installation
AQ348848915086en-000101 / 130R0943