Table of Contents
Advertisement
Operator's Manual: 240 FF Basic Seed Express
Revised 01.2022
™
3.3 MACHINE BREAK-IN
A
special
break-in
developed to ensure the integrity of the seed
tender when first put into service. Follow the
Before Starting instructions and then follow the
Inspections for 1/2, 5, and 10 hour instructions
at the appropriate interval.
After completing these instructions, follow the
normal service schedule in the Maintenance and
Service sections and the engine manual.
Before Starting Work:
1. Read and follow the instructions in this
manual, and the engine manual.
- Read the Pre-Operation Checklist.
2. Check wheel bolt torque and then again at
10, 25, and 50 miles.
- Refer to Section 6.2 Bolt Torque.
3. Start the engine and check the controls.
Be sure that they function properly.
After Operating for 1/2, 5, and 10 Hours:
4. Check the machine fluid levels.
- Refill as necessary.
5. Check the tension and alignment of the
conveyor belt.
6. Check hardware and fasteners; frame to
trailer tie-downs, all fasteners, and wheel
bolts. Tighten to their specified torque.
7. At 10 hours, change the engine oil.
- Check engine manual for the specified oil.
Bulk Seed Tender
®
procedure
has
been
®
3-7
Advertisement
Table of Contents
