Nexo PSR2 Series System Manual page 55

-
Lock safety pins into LS18 connecting plate
Ensure that safety pins are properly locked into LS18s connecting panels.
Connect bumper to first LS18 using "lift" points of XBOWs
-
-
Ensure quick release pins are properly locked
Insert axis in bumper NS-1 predefined hole and secure it with provided "R" clip
-
Bumper holes are numbered #-17 to #17, please refer to NS-1 to determine axis position in relation to
If bumper is flown with 2 hoists, then they should be connected to holes #-17 and #17.
-
Connect hoist hook to bumper axis and lift assembly to sufficient height in order to connect a second LS18
-
Connect second LS18 with X-Bow front articulation holes and rear link bars and ensure quick release pins are properly
locked
-
Repeat above steps for subsequent cabinets
Ensure that safety pins are properly locked into LS18s connecting panels.
Ensure that all quick release pins are properly locked into their position.
-
Lift cluster to NS-1 defined rigging height, secure cluster horizontally to prevent it from rotating
-
Secure bumper with secondary safety steel
PS SERIES HARDWARE SETUP PROCEDURE
IMPORTANT
bumper angle requirements.
IMPORTANT
System Manual PSR2 Series
Page 55 / 109