6.4.2
PS on speaker stand or on LS subwoofer
Required items
-
1 x Speaker stand diameter 35mm (K&M 213 or equivalent)
-
Or NEXO PS pole stand (VXT-PLSTD) for mounting on top of LS
Speaker stand must be rated for assembly weight (40kg rated load min)
Speaker stand must always be installed on a horizontal surface
Stand height and footprint must be defined to prevent assembly from collapsing
Ensure that public is not allowed within a safety area which radius is equal or higher than assembly height.
NEXO PLSTD pole stand only should be used for mounting on top of NEXO LS
LS must always be installed on a horizontal surface
Ensure that public is not allowed within a safety area which radius is equal or higher than assembly height
Procedure
-
Lift PS on speaker stand or on LS with VXT-PLSTD pole stand
-
Test steadiness of the assembly by pushing in all directions
PS SERIES HARDWARE SETUP PROCEDURE
IMPORTANT
R>H
IMPORTANT
System Manual PSR2 Series
H
Page 49 / 109