-
Screw all shoulder screws so that all plates and cabinets are tightened together
-
Flip the cluster upside down to access connector plates located on the down side
-
Repeat all above steps
-
Position the GPI-BUMPER bumper to required angle position and use the four shoulder screws to connect it the bumper to
the top cabinet
-
Flip cluster by 90° so that it is ready to be positioned under the ceiling
-
Four screws 12mm diameter (not provided) are required to secure the bumper under the ceiling
Page 46 / 109
PS SERIES HARDWARE SETUP PROCEDURE
System Manual PSR2 Series