Ps10R2/Ps15R2/Ls600 Mounted On A Ceiling (Vertical) - Nexo PSR2 Series System Manual

6.3.3

PS10R2/PS15R2/LS600 mounted on a ceiling (vertical)

Required items
- 1 x VNI-LBRK (allows cable suspension, holes for cable suspension are 10mm diameter)
- 2 slings and corresponding shackles (not provided)
OR
- 1 x VNI-ABRK (allows rigid suspension)
Ensure that the ceiling is strong enough to hold 4 times PS or LS weight and that the cable suspension
system required to install the cabinet under the ceiling is properly dimensioned.
Procedure
- Remove the four TORX screws holding connector plates on upper side of PSR2 or LS600
- Remove the connector plate from PSR2 or LS600 cabinet
Fill each screw hole with Loctite 243 or equivalent
-
Position external plate from VNI-LBRK kit or VNI-ABRK kit and secure it using 2 of the 4 shoulder screws supplied with this
-
kit
- Position bracket from VNI-LBRK kit, or VNI-ABRK and secure it to the cabinet using the 2 remaining shoulder screws
supplied with this kit.
Slings and shackles (not provided) are required to secure the cluster under the ceiling
-
PS SERIES HARDWARE SETUP PROCEDURE
IMPORTANT
System Manual PSR2 Series
Page 41 / 109