Fitting The Blade - Husqvarna FS 400 LV Manual

Fitting the blade

Motor off.
Disconnect by removing the plug.
· Set the machine in the high position.
· Disconnet the water pipe from the blade guard.
· Unscrew the nut (K) from the guard.
· Lift up guard (A).
· Fit the diamond blade.
Take care about the direction of rotation
which is shown by an arrow on one of the
faces (direction of rotation on the right
side of the guard)Make sure the contact
faces of flanges (B and C) of blade and
the axle are clean.
· Firmly lock screw (D) using the spanner supplied
with the machine whilst immobilising the blade
byhand.
· Replace the protection guard (A).
· Close the guard water tap (G) [Fig 2].
· Reconnect the water pipe (G).
· Tighten nut (K).
Replace all protective covers for your
safety and that of other persons.
Note : how to adjust the <<zero>> according to the
diameter of the blade :
· The blade must be closed to the floor.
· Loosen the screw (H).
· Line up the <<zero>> with the pointer, then tight
the screw (H).
组装
– 7
Chinese