Assembling And Adjustments; Fitting The Blade - Husqvarna K970 II Ring Operator's Manual

Hide thumbs Also See for K970 II Ring:
Table of Contents

Advertisement

Available languages

Available languages

Fitting the blade

WARNING! It is forbidden to reconstruct
!
a used blade. A used blade may be
weakened. A reconstructed blade can
crack or break into pieces and seriously
injury the operator or other persons.
WARNING! Check that the blade is not
!
damaged before fitting it on the machine.
Damaged blades can disintegrate and
cause serious personal injury.
NOTICE! Replace the drive wheel when fitting a new
blade. A worn drive wheel can result in the blade
slipping and becoming damaged.
Inadequate water flow drastically shortens the life of the
drive wheel.
Wipe off any dirt from the surface of the blade.
Loosen the locking nuts on the support roller cover.
Unscrew the adjuster screws a few turns.
10 – English

ASSEMBLING AND ADJUSTMENTS

Loosen the knob to offload the springs.
Remove the four screws holding the support roller
guard using a 6 mm hex key and lift off the cover.
Fit the blade.
The blade has a groove (1) on one side that acts a the
guide groove for the support rollers. Ensure that the V-
shaped edge of the blade enters the drive wheel and
that the blade's guide groove fits in the guide rollers.
Ensure that the V-shaped edge of the blade enters
the drive wheel and that the blade's guide groove fits
in the guide rollers. See instructions in the section
"Blades".
Press in the guide roller if necessary, so that it climbs
into the groove on the blade.

Advertisement

Table of Contents
loading

This manual is also suitable for:

K970 iii ring

Table of Contents