Incidents During Sawing; Maintenance; Scrapping - Husqvarna FS 400 LV Manual

Incidents during sawing

Several causes can result in the blade stopping in
the sawing groove or the machine stopping:
· Tension of the belt.
· Lack of fuel.
· Excessively fast feed or descent, etc.
· In all cases remove the blade from the groove and
check the machine thoroughly. Entrust repairs to
authorised dealer only.

Maintenance

"Engine Maintenance" : refer to the
engine maintenance booklet.
Lubrication
Dispose of the old oil as laid down by
the regulations in force.
· Apply a moderate amount of bearing lubricant
to the nipples in the depth adjustment chassis
(depending on the frequency of use).
· The spindle bearings must be greased after 8
hours of use, with a grease gun by pumping three
to five times the grease into the greaser of the
bearings. Only use a Super lithium 12 based grease
in compliance with the NLG1 GRADE 2 consistency.
· Every 40 hours grease : depth control adjustment
screw.
Motor belt tension
Never set belts beyond original tension.
After several hours of use it may be necessary to
adjust the tension of the belts (moderately). To do
this proceed as follows :
· Release the screws fixing the motor to the
chassis.
· Turn the tensioning screw (N) at the front of the
machine one quarter turn; this screw pushes the
motor backwards [FIG. 1].
· At normal tension, counterlock the nut of the
screw (N).
· Relock the motor fixing screws.
´®z+RF;¶3i¨
´®z+RF;¶3i¨
10 – Chinese
维修
Important recommendations
The manufacturer declines all
responsibility for loss or damage
resulting from misuse or any
modification, alteration or powering
that does not conform to the
manufacturer's original specifications.
· P e r i o d i c a l l y t i g h t e n a l l n u t s a n d b o l t s ,
particularly after the first few hours of
operation.
· Check the tension of the belt. Tighten it, as
instructed.
· When storing the machine, we recommend removing
the blade and storing it carefully.
· Check that the blade is properly sprayed by
inspecting the holes in the fork regularly.
· Tighten the blade firmly.
· Make sure the contact faces of flanges, blade and
axle are clean.
Repairs
We carry out all repairs in the shortest possible
time and at the most economical prices (see overleaf
for our address).
Spare parts
For quick supply of spare parts and to avoid any
lost time it is essential to quote the data on the
manufacturer's plate fixed to the machine and the
part number of the part to be replaced with every
order.
Note! The instructions for use and spare parts found
in this document are for information only and are not
binding.As part of our product quality improvement
policy, we reserve the right to make any and all
technical modifications without prior notice.

Scrapping

In the event of deterioration and
scrapping of the machine, the
following items must be disposed of in
accordance with the requirements of
the legislation in force.
Main materials :
· Motor : Aluminium (AL) - Steel (AC), Copper (CU),
Polyamide (PA)
· Machine : Steel sheet (AC), Cast iron (FT)
Aluminium (AL)