Assembling And Adjustments; General; Checking The Spindle Shaft And Flange Washers; Checking The Bushing - Husqvarna K6500 II Operator's Manual

General

WARNING! Always pull out the plug from
!
the outlet socket before cleaning,
maintenance or assembly.
Husqvarna's blades are approved for hand-held power
cutters.
Checking the spindle shaft and
flange washers
When the blade is replaced with a new one, check the
flange washers and the spindle shaft.
• Check that the threads on the spindle shaft are
undamaged.
• Check that the contact surfaces on the blade and the
flange washers are undamaged, of the correct
dimension, clean, and that they run properly on the
spindle shaft.
Use only flange washers supplied by Husqvarna, min.
diameter 105 mm/4.1".

Checking the bushing

The arbor bushings are used to fit the machine to the
centre hole in the cutting blade. A plate on the blade guard
indicates which bushing has been factory-fitted.
• Check that the bushing on the machine's spindle shaft
corresponds with the centre hole of the cutting blade.
Use only bushings supplied by Husqvarna. Those
bushings have been designed for your power cutter.

ASSEMBLING AND ADJUSTMENTS

Checking the direction of the
blade rotation
• When using diamond blades make sure that it rotates
in the direction indicated by the arrow on the blade.
The direction of rotation for the machine is shown by
arrows on the cutting arm.

Fitting the cutting blade

• The blade is placed on the bushing between the inner
flange washer (A) and the flange washer (B). The
flange washer is turned so that it fits on the axle.
• Lock the shaft. Insert a tool in the hole in the cutting
head and rotate the blade until it is locked.
• Tightening torque for the bolt holding the blade is: 25
Nm (18,5 ft-Ibs).
–
English 11