Troubleshooting; Incidents During Sawing - Husqvarna FS 3500 G Operator's Manual

Incidents during sawing

CAUTION! If the engine or blade stops for any reason, raise the blade completely from the cut. Set the Engine start switch to
STOP position. Press the Machine stop on the control panel. Inspect the machine thoroughly before restarting the engine.
• Entrust all repairs to your authorized dealer only
P o r b e l m C a
E n
Lack of water signals the Water safety switch
to stop the engine
Engine stops during
The Machine stop has been pressed down
sawing
Excessively fast cutting will stall the engine
Circuit breaker fuse is blown
The diamond blade stops
Drive belt tension is inadequate
during sawing
The valve that controls the saw lowering is
Saw lowers too fast
open too much.
The blade has become dull or it is too high
The blade cuts too slowly.
feeding pressure

TROUBLESHOOTING

u s e
g n i e o t u f o u f e . l
P o s s b i e l a t c o i n
R e l l fi i w h t u f l e
Disengage the Water safety switch and check water
supply, then restart the engine.
Reset the machine stop by pulling the knob outward.
Listen to the sound of the engine. If the engine starts
to slow down compensate by pulling Forward/Reverse
control lever backwards to decrease feeding and
prevent stalling the blade.
Inspect and replace fuses
The ROSTA tensioner or drive belt needs to be
replaced.
The lowering rate of the saw can be adjusted using the
Saw lowering speed control knob on/under the
hydraulic pump. If the saw lowers too quickly, turn the
knob clockwise until an adequate lowering rate is set.
Decrease the cutting depth and engine speed for a
short time
– 31
English