4.7
Electrode positioning
To verify the correct position of the ignition electrode (Fig. 12), you
need to separate the combustion head from the rest of the burner.
Proceed as follows:
loosen the 4 screws 3)(Fig. 11) and remove the cover 1);
remove the screws 2) from the two sliding bars 5);
install the extensions 15) and re-screw the screws 2);
remove the two screws 4);
pull back the burner on the sliding bars 5) of about 4";
disconnect the electrode lead, then unthread the burner com-
pletely from the sliding bars;
remove the screw 1)(Fig. 13) and extract the inner part 2) of
the head;
check the correct position of ignition electrode, as shown in
Fig. 12.
Measures must be respected.
WARNING
Re-install all components with reverse procedure.
20094575
Installation
1/ 20"
1
2
18
GB
D10453
D10444
Fig. 12
Fig. 13