Advertisement
Springboard
¨
Replacement parts
©
2001 Steelcase Inc.
Grand Rapids, MI 49501 U.S.A.
Printed in U.S.A.
Manager Seating
Task Seating
-Height Adjust Column Assembly Replacement
(also applies to Base, and Telescopic Cover Replacement)
-Cushion Assembly Replacement
(also applies to upright, back shells, and seat shell replacement)
-Back Replacement
-Seat Replacement
-Arm Replacement
R
Page 1 of 6
939504514 Rev F
Advertisement
Table of Contents
Related Manuals for Turnstone Springboard
Summary of Contents for Turnstone Springboard
- Page 1 Springboard ¨ Replacement parts Manager Seating Task Seating -Height Adjust Column Assembly Replacement (also applies to Base, and Telescopic Cover Replacement) -Cushion Assembly Replacement (also applies to upright, back shells, and seat shell replacement) -Back Replacement -Seat Replacement -Arm Replacement ©...
- Page 2 Height Adjust Column Assembly Replacement (also applies to Base, and Telescopic Cover Replacement) Adjust chair to maximum seat height. Turn chair upside down and set on stand or table. To remove base, tap firmly alternately on opposite arms near hub with rubber or leather mallet. Slide plastic telescopic cover all the way down column.
- Page 3 Cushion Assembly Replacement (also applies to upright, back shells, and seat shell replacement) If chair has arms, remove per arm removal instructions page 5. Adjust chair to maximum seat height. Turn chair upside down and set on stand or table. Back Remove upright and back assembly by removing upright screws and tapping upright out of chair...
- Page 4 Cushion Assembly Replacement (also applies to upright, back shells, and seat shell replacement) Seat Remove E-Clips from grooves of the pivot pins then remove the pivot pins on either side of chair control using screw driver or punch and mallet. Remove chair control, column, base assembly from top plate/stretcher assembly.
- Page 5 Arm Replacement Adjust chair to maximum seat height. Turn chair upside down and set on stand or table. Remove screw from the stretcher. Pull out arm and replace. (May require tapping arm with rubber mallet.) IMPORTANT - SET TORQUE OF SCREWS TO 175 -200 IN/LBS. Note: Turn chair upsidedown and look for a lable with build schedule information on it.
- Page 6 Flip Arm End Cap Replacement To remove end cap, strike underneath side with a rubber mallet. To assemble new end cap, place on top of arm mechanism and strike with the rubber mallet. End cap is held in place with a spring clip. Make certain end cap is held on securely.
Need help?
Do you have a question about the Springboard and is the answer not in the manual?
Questions and answers