APEX
®
3 SERIES TIG PENDANT MANUAL
Settings
The Settings Menu shown in FIGURE 37- Settings
Screen – provides access to the Production Monitor-
ing feature. When enabled, it will automatically archive
a summary of each weld to an inserted USB drive. Use
the Right Toggle to turn this feature ON/OFF.
FIGURE 37 - Settings Screen
How To Take A Snapshot
If a USB drive is inserted into the APEX 30M, APEX
30S or APEX 3000, the Pendant will allow a snapshot
to be taken from the screens shown in FIGURE 31,
FIGURE 32, and FIGURE 38. A snapshot provides
detailed information concerning the systems current
configuration and the status and is initiated by pushing
the SNAP Selection button.
FIGURE 38 - Snapshot System Fault
The snapshot process may take several minutes to
complete during which time a status screen like the
one shown in FIGURE 39 - Snapshot Status Screen
is presented.
FIGURE 39 - Snapshot Status Screen
A-40
OPERATION