Operator Navigation Chart - Lincoln Electric APEX 3 Series Operator's Manual

APEX ® 3 SERIES TIG PENDANT MANUAL

Operator Navigation Chart

➁
➂
SETUP
Oscillation
SWAP
➅
Log In Screen
ENTER

LONG PRESS MENU BUTTONS
➄
MENU
BUTTONS
Travel Setup
EXIT
➀
Setup Screen
LOAD
Idle Screen
START
STOP
BUTTON
Jog Screen
EXIT
A-51
OPERATOR VIEWS
Supervisors will have access to
all levels of the system, however
the system is designed to lock
out operators from higher level
functions at the supervisor's
discretion.
Operators have access to a
limited number of screens.
The following flow chart provides
a reference of all the screens
available, how to get to them and
navigate back.
1. After logging in the operator can
choose any existing program
to load.
Active Weld Screen
➃
2. The loaded program will move
into the Idle Screen in test mode.
3. Return to the Setup Screen by
pressing the Setup Selection
button.
4. Move into Active Test to verify all
weld settings, or Active Weld to
begin welding.
5. From the Idle Screen long
pressing the menu buttons
will take the operator to the
corresponding Jog or Oscillation
Menu. Use the menu buttons to
switch between the two menus.
6. It may be necessary to change
the weld head orientation. This
allows the user to set how the
weld head steers and operates
in relation to their position.
Pressing EXIT from any screen
will return the operator to the
previous menu.
Refer to this Operator's Manual
for more detailed operating
instructions.
OPERATION