System Log In; Fast Movement; Login - Lincoln Electric APEX 3 Series Operator's Manual

APEX ® 3 SERIES TIG PENDANT MANUAL

System Log In

When powered on, the system will go through a self-
calibration routine. Make sure the torch is free to move
before starting the system.
When the calibration routine is complete, the user will
be presented with a Log In Screen – see FIGURE 7 -
Log In Screen Buttons.

Fast Movement

Fast movement using the steering knob is enabled on
this screen. See FIGURES 5, 5A and 5B - Fast Move-
ment. Use the steering knob or left and right toggles
for navigation and selection.
FIGURE 5 - Fast Movement Steering Knob
FIGURE 5A - Fast Movement Left Toggle
FIGURE 5B - Fast Movement Right Toggle

Login

The system requires a four digit log code in to log in.
Use the left toggle to change from one variable to the
next. Use the right toggle to change the selected variable.
FIGURE 6 - Idle Screen Default
Press the Enter selection button when user code has
been entered. Once a four-digit code is accepted the
system automatically moves into the default Idle screen
see FIGURE 6 - Idle Screen Default. This screen is
shown when a supervisor logs into the system.
From the Idle screen is possible to move into the Setup
screen, Jog and Oscillation screens as well as switch
between test and weld modes.
Note: The values shown on each screen are represeta-
tive only.
A-15
OPERATION