Design Features; Controls And Settings - Lincoln Electric RANGER 305 D Service Manual

RANGER 305D
DESIGN FE TURES
• Single, full-range output control dial.
• 4 welding modes: CC-stick, downhill stick welding on pipe, CV
wire welding and Touch-Start TIGTM (eliminates high frequency
and tungsten contamination).
• Output at welding terminals controlled by electronic contactor.
Can be switched to "On", or to "Remotely Controlled".
• Many wire feeder combinations: 14-pin connector for Lincoln
wire feeders LN-25, LN-23P, LN-7, LN-8 operates when using a
Lincoln wire feeder with the appropriate control cable.
• Smart machine! Remote operation and Magnum® spool gun;
42VAC for LN-742 and Cobramatic® wire feeders.
• 12 gallon fuel capacity allows you to run an extended day.
• Easily check fuel level during operation and refuelling with
highly visible fuel gauge. Some models have gauge located next
to fuel cap on case top. Some models have gauge located on
front panel.
• Voltmeter and ammeter display actual volts and amps at output
terminals when welding.
Longer engine life, reduced noise emissions and great fuel
•
economy with the automatic engine idler.
Conveniently located engine maintenance label under top
•
engine door.
Engine hour meter for scheduled maintenance.
•
Electric start.
•
Oil drain valve (no tools required).
•
See spec pages for watts of continuous duty AC generator
•
power.
See spec pages for Amp and voltages output specs. Circuit
•
breaker protection.
See spec pages for receptacle information.
•
CONTROL ND SETTINGS
The diesel engine stop/start and idler controls are located on the
case front panel. The welder controls are also located here. See
Figure B.1.
B 3
OPERATION