Table of Contents
Advertisement
The Troubleshooting Guide, shown below, is included to
help you quickly locate problems that can happen using
your 2210 Series Weatherproofer I. Follow all safety
precautions stated in the previous sections when making
any adjustments to your machine.
PROBLEM
FIELD NOT LEVEL BEHIND
WEATHERPROOFER. RIDGE AT
CENTER OF SWATH
FIELD NOT LEVEL, RIDGE AT OUTSIDE
OF SWATH
STRIPS OF UNTILLED SOIL NEAR
CENTER OF SWATH
Troubleshooting Guide
PROBABLE CAUSE
Frame not level front to rear:
Rear disc gangs at too aggressive angle:
Rear disc gangs operating too deep:
Rear disc gangs too close together:
Frame not level front to rear:
Front disc gangs too aggressive an angle
Disc gangs operating deeper than
necessary:
Speed too fast front discs throw soil
beyond reach of rear discs:
Frame not level front to rear:
Disc gangs operating too shallow:
Chapter 5
SOLUTION
Lower machine to working depth and drive
a short distance. Stop and check if
frame is level. Adjust radius rod as
required to level machine.
Adjust rear disc gangs to a lesser angle.
Raise rear discs to desired depth (3" to 6")
Loosen u-bolts holding disc gang shanks
to 5 X 3 tube and slide disc gangs out.
Lower machine to working depth and drive
a short distance. Stop and check if
frame is level. Adjust radius rod as
required to level machine.
Adjust front gangs to a less aggressive
angle.
Raise front disc gang to operate at desired
depth (3" to 6").
Change to slower gear or change front
disc gangs to a lesser angle.
Lower machine to working depth and drive
a short distance. Stop and check if
frame is level. Adjust radius rod as
required to level machine.
Lower disc gangs to operate at deeper
depth.
5-1
Advertisement
Table of Contents
