Table of Contents
Advertisement
It is very important that your new 2210 Series
Weatherproofer be properly assembled, adjusted, and
lubricated before use. Illustrations to assist with the
assembly process are provided in "Standard
Specifications" on page 2-1. Illustrations are provided
in this section to show proper shank, disc gang, and
mounting bracket spacings. Remove paint from grease
fittings and replace any that are damaged or missing. Be
sure to replace bolts, clips, etc. in the same place from
where they were removed.
To insure assemblies are aligned, insert all bolts and
leave the nuts loose until completion of final
assembly. Use lockwashers or flat washers where called
for. Spread all cotter pins.
After completion of final assembly, tighten all nuts evenly
to prevent misalignment, distortion, or binding. Tighten all
bolts and nuts to the recommended torques shown in
"General Torque Specifications" on page 2-2.
Disc blades are extremely sharp. Exercise
extreme care when working on or near disc
blades. Do not allow discs to roll over or fall onto
any bodily part. Do not allow wrenches to slip
when working near disc blades. Never push
wrenches toward disc blades. Do not climb over
machine above disc blades. Failure to stay clear
of disc blade edges can cause serious personal
injury or death.
Do not attempt to lift heavy parts (such as the
frame, disc gangs, rock shaft, and pull hitch)
manually. Use a hoist or a fork lift to move these
parts into position.
DANGER
WARNING
Assembly Procedures
To prevent accidental lowering:
1. All hydraulically elevated equipment must be
locked out using the cylinder lockouts:
2. Lower equipment to the ground while
servicing or when it is idle.
Failure to take measures to prevent accidental
lowering may result in serious personal injury or
death.
Be sure depth stops are equal lengths on all
cylinders. Using unequal depth stop lengths can
cause permanent equipment damage.
Be sure to bleed the hydraulic system of all air in
lines after installation. Failure to bleed the system
of all air can result in improper machine
operation.
Chapter 3
DANGER
CAUTION
CAUTION
3-1
Advertisement
Table of Contents
